[ANN] [XMG] MAGI | CPU mining | mPoW | mPoS | [MagiPay]

[MilkandPie4U]

I have a problem with the wallet:



After a while the connections go back from 4 until 0 and the program says wallet offline.

What can be the problem?

So much staking and so a low reward is also not right....

Any ideas?

Hi,

Do you have the following nodes in your magi.conf?
addnode=104.128.225.215
addnode=104.131.42.100

That staking reward does look a bit low for such a huge amount. Not sure on the technicalities of that, maybe its calculated in a different way - I think you are already using the split and combine mecahnisms, so wont ask about that.

EDIT: just spotted the network weight - that doesn't look right at all (unless its to do with the small number of connections) - I wonder if you are on an incorrect block chain - I'd be inclined to try to resync it if the addnodes list don't improve the situation

You can find some more nodes here:
https://chainz.cryptoid.info/xmg/#!network

I also had this problem today, I restarted the wallet, and I am good now. I must have been on a fork.

[logictense]

Good news for the Magi community.
Proof of Interest campaign IV:

Interest 6.7% 

Last interest-shares will be paid today!!

Great news - I hope I managed to follow all the rules correctly =)

I was taking part in the previous three campaigns and what I got was a middle finger. Can u tell me what dividends I will get if I do support ur ruse?

[111magic]

Could you pls be a little more specific?
I don't understand what you mean.
If you rather would like to send it pm you are very welcome.

[The Frisian]

I also had this problem today, I restarted the wallet, and I am good now. I must have been on a fork.

The error log says:

connection timeout
ERROR: mempool transaction missing input
received block 54ce5c1e3e16d1c4184a
ProcessBlock: ORPHAN BLOCK, prev=9d47268d22c52279bfb4
trying connection 193.83.31.204:8233 lastseen=300.9hrs
received block 9d47268d22c52279bfb4
ProcessBlock: ORPHAN BLOCK, prev=b0f5f69d62e22a017048

leading to all connections closed and wallet offline

[MilkandPie4U]

Good news for the Magi community.
Proof of Interest campaign IV:

Interest 6.7% 

Last interest-shares will be paid today!!

WOOT WOOT, just got my Proof of Interest. Thank you!

[111magic]

You are welcome amigo!
Cheers!

[111magic]

http://www.blockchaindynamics.net/voting.html

Friendliest Community 2016

[ X ] Magi

Nothing more to say I think  

Bumping this towards the top of the new page - maybe it'll attract a few more votes =)

Voted! Thanks for link Vin!
And for the bump Starmman.

Reminder!!! Help our awesome Magi community with more votes. It takes 10 seconds to vote!
Check the link above!

[starmman]

http://www.blockchaindynamics.net/voting.html

Friendliest Community 2016

[ X ] Magi

Nothing more to say I think  

Bumping this towards the top of the new page - maybe it'll attract a few more votes =)

Voted! Thanks for link Vin!
And for the bump Starmman.

Reminder!!! Help our awesome Magi community with more votes. It takes 10 seconds to vote!
Check the link above!

Just voted again - as I'm back home again - new IP =)

Thanks very much for the Magi POIIV payment - I'll use it to help either Bittrex or Novacoin liquiduty

[Lightsplasher]

http://www.blockchaindynamics.net/voting.html

Friendliest Community 2016

[ X ] Magi

Nothing more to say I think  

Bumping this towards the top of the new page - maybe it'll attract a few more votes =)

Voted! Thanks for link Vin!
And for the bump Starmman.

Reminder!!! Help our awesome Magi community with more votes. It takes 10 seconds to vote!
Check the link above!

Just voted again - as I'm back home again - new IP =)

Thanks very much for the Magi POIIV payment - I'll use it to help either Bittrex or Novacoin liquiduty

I voted too.

Thanks for the nice POIIV payment, I really appreciate that!  I'll be trading on both these exchanges too.

[111magic]

You are welcome Starmman & Lightsplasher

Personally i really like the Proof of Interest campaigns!

[Lightsplasher]

I also had this problem today, I restarted the wallet, and I am good now. I must have been on a fork.

The error log says:

connection timeout
ERROR: mempool transaction missing input
received block 54ce5c1e3e16d1c4184a
ProcessBlock: ORPHAN BLOCK, prev=9d47268d22c52279bfb4
trying connection 193.83.31.204:8233 lastseen=300.9hrs
received block 9d47268d22c52279bfb4
ProcessBlock: ORPHAN BLOCK, prev=b0f5f69d62e22a017048

leading to all connections closed and wallet offline

I experienced a problem with orphans earlier that restarting the wallet fixed.

I've had problems with other coins not being able to establish a connection.  One thing that work for me was to remove all the previous "addnode" commands from the configuration file and just add some new ones from a block explorer or recent nodes from an exchange.  You might try that.  There are some you can find at https://chainz.cryptoid.info/xmg/#!network under the node list button.

[The Frisian]

It's working again.



But the network weight is far too low so I think many wallets have problems.
Within 5 min. I was on top of the staking list, while not present there for more than 10 hours.

I decided to download the blockchain again and start again.
After a few restarts because of the orphan problem mentioned above I resulted in a bad wallet.
(only 8K of my coins came back in the wallet)
After a repairwallet and restart all the coins came back.

But I think there's still something wrong.

[bitcampaign]

wallet really works well I hope wallet still connect synchronous

[111magic]

wallet really works well I hope wallet still connect synchronous

I did all payouts for the Proof of Interest campaign IV and wallet works fine!

[MilkandPie4U]

It's working again.



But the network weight is far too low so I think many wallets have problems.
Within 5 min. I was on top of the staking list, while not present there for more than 10 hours.

I decided to download the blockchain again and start again.
After a few restarts because of the orphan problem mentioned above I resulted in a bad wallet.
(only 8K of my coins came back in the wallet)
After a repairwallet and restart all the coins came back.

But I think there's still something wrong.

Glad to see your wallet is working again. It is very important when 1st starting the xmg wallet to leave staking off until the wallet is full synced.
 

[Abiky]

Glad to see you again. It's been some time for me on the work stuffs as well. I'm not yet into Raspberry, but someone did a guide as I remember. I'll try to find it out. Also I'm interested to get a Pi like for staking; either way I'll figure out a guide.  

Glad to see you too Joe. It is nice to be back with Coin Magi as it is one of the best altcoins out there with a good community and solid development. I've become interested into staking XMG with a Raspberry Pi 3, but if it is possible to stake on the Pi Zero too, then I would prefer it as it is much smaller. 

You mean this one Joe: https://raspi2miner.wordpress.com/tag/xmg/

https://www.google.nl/url?sa=t&source=web&rct=j&url=/amp/s/raspi2miner.wordpress.com/2015/11/29/magicoin-xmg-miner-for-raspberry-pi-2/amp/&ved=0ahUKEwjCvuS_gsvRAhWJQBoKHaa5C4AQFgglMAI&usg=AFQjCNE_RoINm_s-5sO0pyiyuDWQIwL55Q&sig2=5hb0G-5SD0jPSZ-jMsEmjg

Hey 111magic! Long time no see. Thanks for sharing this link towards the Raspberry Pi wallet build. I've been anxious to start my very own XMG Raspberry Pi node and start staking within it 24/7. Since the Pi uses very minimal electricity, it should be very convenient to stake and mine some XMG with it.

I've been holding so many altcoins, and have been trying to keep up to date with all of them so I haven't got time to check out on Magi. Still, I would love to get back to buying and staking XMG for the next POI (if there is going to be a next one soon). 

I might give that a go myself some time. I want to also start researching how to create apt-get packages - would be great to have a apt-get install magi-pi

Welcome back Abiky good to see you on the forums again

Sounds great. It would be very handy to quickly setup your Raspberry Pi wallet with just a single command. There are many users which are not very tech savvy when it comes to compiling and building a wallet, so this would make it easier for them.

I'm glad to see you too Starmman. It has been quite some time since I have been away from Coin Magi, since I have been very busy with other altcoins as well as college stuff. Whenever I have free time, I will try to keep updated with Magi. Just got interested into making my very own Raspberry Pi wallet to stake some Magi and leave it working for 24/7 generating you some "free" XMG with no effort involved. 

[stacey2911]

Good news for the Magi community.
Proof of Interest campaign IV:

Interest 6.7% 

Last interest-shares will be paid today!!

Hey magic, I haven't received anything yet 

Registered at the Bitcoingarden thread under the same handle as here, Stacey2911. Address was 9KYKcWV3wjWNy3xaFyftTmXHvuqjwzB776 and I've doubled my balance since entry.



That's my last few months of coins in, doesn't include me recombining blocks into my stake address. No interest from the campaign has come through yet.

[Redrover]

Good news for the Magi community.
Proof of Interest campaign IV:

Interest 6.7% 

Last interest-shares will be paid today!!

Thank you very much Magic!  Nice interest yet again!

[joelao95]

I have a problem with the wallet:

..

After a while the connections go back from 4 until 0 and the program says wallet offline.

What can be the problem?

So much staking and so a low reward is also not right....

Any ideas?

I believe magi's PoS seems working well, cause it makes one having such a huge amount of coins being too much concerned about the rewards. No offense. It's kinda coming down to how so-called PoS-II works; be sure to check if what you PoSed matches with APR; if not, then could be strategy of putting how much coins in stake..

As to the network height, it's supposed to be fluctuating.. However, I'll get it into be on the to-do-list of the mPoS things that's part of the works after this release.  

[111magic]

I have a problem with the wallet:

..

After a while the connections go back from 4 until 0 and the program says wallet offline.

What can be the problem?

So much staking and so a low reward is also not right....

Any ideas?

I believe magi's PoS seems working well, cause it makes one having such a huge amount of coins being too much concerned about the rewards. No offense. It's kinda coming down to how so-called PoS-II works; be sure to check if what you PoSed matches with APR; if not, then could be strategy of putting how much coins in stake..

As to the network height, it's supposed to be fluctuating.. However, I'll get it into be on the to-do-list of the mPoS things that's part of the works after this release.  

Thanks Joe. Very nice.

Stacey2911 i will check it. I'am only human and could make a mistake. I will send you a message after the check.